USB connection issue with new Mac install - LightBurn Software

They aren’t setting those numbers, that’s just echoing the values stored in the controller. This is how LightBurn knows the maximum: Typing manual S values would require you to be in the correct mode. You’d need to type G1 with a feed rate first, like G1 F100, and then you can use M3 and set an S value. If you aren’t in G1 mode, the S values are ignored because the “spindle” isn’t running during G0 moves, only G1.

How to Install LightBurn and How to Switch between LightBurn and EZCAD? : r/Laserengraving

Lightburn Setup and Configuration - X-Carve Laser Upgrade

Official LightBurn Camera - Cohesion3D

Lightburn USB Issues on Mac OS X - John's Tech Blog

FoxAlien Reizer 20W Laser Engraver with Lightburn Software Bundle Kit

Aurora Installing Lightburn (non-Pro)

Brand new xtool won't connect through usb : r/xToolD1

Connecting A Thunder Laser To LightBurn Via USB

Lightburn USB Issues on Mac OS X - John's Tech Blog